How to Get More Bass Power From Your Vehicle Music System
Feb 4, 2010 More Saving
Top Sites For Money Saving Tips:
In just seven steps this article will guide you on How to Install a Sub woofer in a Factory Stereo. Very often people who are passionate about adding new additional features to their car stereo like sub woofers take the help of audio professionals to do the job. But this job is not at all complicated and can be done without any experience by following simple steps. In this article we shall also discuss the importance of installation of sub woofers, tips and warning for doing this job.
Depth and powerful sound are important for good quality of music. Speakers can be installed at various places inside the car like door panels, dash and rear decks. They enhance the sound effect for higher notes. But to enjoy lower tones adding a sub woofer to a factory stereo is the best choice. Let us see how to do that now.
The first step is the disconnection of grounding cable and the battery of the vehicle. The grounding cable is connected to the vehicle’s frame through the lead that is negative. With the help of a Philips screw driver the clamps of the cables are all loosened and kept separate from the negative lead.
The next step is to search for the amplifier in the vehicle. In most cases it is factory made. The manual which is issued along with the vehicle by the manufacturer is to be referred often. The sub woofer is placed either in the car area in the rear end in the case of hatch backs or SUV or in the trunk of the car. The speaker wires are then connected to the corresponding outputs that is positive and negative ends of the amplifier.
The speaker wires are routed to the place where the sub woofers are located. There are possibilities for it to be located some where away from the sub woofers, in such cases the wires can be sent through the carpets in the floor of the car. The trim panels which are present at the door openings are pried free with the help of a trim panel removal tool.
The carpets are lifted and the wires are routed through this. Hiding the wires gives a custom look and avoids clumsy look. The trim panels are replaced manually. To fit them properly, pressure must be applied uniformly through out the panel’s length.
The speaker is then connected to the input corresponding to each of the sub woofer. The positive is connected to the positive terminal and the negative is connected to negative. The grounding cables are reconnected to the vehicle battery’s lead post which is negative. The cable’s clamp is placed in correct position around the lead and then using a Philips screw driver it is tightened so as to avoid loosening of the clamps.
Knowing how to install a sub woofer in a factory stereo is of great importance in maintaining a car.
Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.
Related Articles
Tags: bass, cars, cars_and_trucks, More Saving, Radio, subwoofer, Woofer
Leave a Reply